Regency bellavista B36XTCE - Conversion Kit #578-977 from NG to LP

52 | Bellavista® B36XTCE-11 Gas Fireplace
installation
CONVERSION KIT #578-977 FROM NG TO LP
for B36XTCE using SIT 885 NOVA Gas Valve
B36XTCE/ B36XTE-11
1
02.21.19
920-033
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
1. Shut o󰀨 the gas and electrical supply.
2. Remove the mesh barrier.
3. Open the flush door and remove the
door.
4. Remove the logs and embers (if already
installed).
5. Loosen the 2 screws holding the Burner
Assembly to the firebox base. Slide the
Burner Assembly to the left to release it
from the orifice and lift out.
Remove the 2 screws, push Burner Assembly
to the left and lift out.
Each Kit contains one LP
Conversion Kit # 578-977
Conversion Kit Contains:
Qty. Part # Description
1  904-645 BurnerOrice#51
1 904-529 5/32" Allen Key
1  918-590 Decal"Converted
to LPG"
1  908-528 Red"LP"label
1  910-037 LPInjector(Pilot
Orice)
1 911-011 Stepper Motor
1  920-033 InstructionSheet
Installation of LP
Conversion Kit:
10. Re-install pilot cap, wire clip and pilot
shield.
11. Remove burner orifice with a 1/2"
wrench. Use another wrench to hold on
to the elbow behind the orifice. Discard
orifice.
12. Reinstall new burner orifice LPG
stamped #51 and tighten.
7. Remove the wire clip below the pilot cap.
9. Unscrew the pilot orifice with the allen key;
then replace with the LPG pilot orifice,
provided in the kit.
6. Remove the pilot shield by removing 2
screws.
Pilot retainer clip
8. Pullo󰀨thepilotcaptoexposethepilot
orice.
14.Reinstallburnerassembly.
15. Adjust aeration accordingly.- see
manual for details.
16. Attach the label “This unit has been
converted to LPG” near or on top of the
serial # decal.
17. Replace yellow “NG” label with red
“LPG” label.
18. Reverse steps 4 - 1.
19. Check for gas leaks.
20. Check inlet and outlet pressures.
21. Check operation of flame control.
13. Remove regulator and discard. Install the
Hi/Lo pressure regulator onto the valve
with 2 screws as shown below.
Installer Notice:
These instructions must be left with the
appliance.