54 | Bellavista® B36XTCE-11 Gas Fireplace
installation
OPTIONAL BLACK ENAMEL PANEL INSTALLATION
918-807a
05/15/12
1
B36X / XT
BLACK ENAMEL PANEL INSTALLATION
Black Enamel Panels
• Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any fi n-
gerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
5) Repeat step 4 for left side panel.
6) Reverse step 1.
Final Installation
4) Remove 1 screw (see inset A), position right side panel in fi rebox -
position panel clip in place and secure with 1 screw (see inset B).
Tighten the screw.
A
B
1) Remove the heat defl ector by removing the 2 screws securing the
heat defl ector to the top of the fi rebox (see Diagram 2).
Heat defl ector
Diagram 2
Diagram 6
Diagram 1
2) Install the back panel fi rst - use care when clearing the burner assembly
and rear log tray, so panel is not scratched.
3) Install the top panel next - slide the panel in over top of the back panel
- orient the panel so the fold in the metal faces in (see inset A).
RIGHT
BACK
LEFT
TOP
Diagram 3
Diagram 4
Diagram 5
Fold
A
To Next Page
Loading...
