Regin RCF Series User Manual

44 Chapter 17 Modbus signals RCF manual
Coil status register
Name of signal Type
Modbus
address
Default
value
Description
Not used in this model
L,1
1
0
RC_Setp_L.RegioShutDown L,1 2 0 Puts the unit in Shutdown mode.
RC_Setp_L.RegioFireAlarmStop L,1 3 0 Places the unit in Shutdown mode and
prevents it from being activated again,
unless this value is first set to “0”.
RC_Setp_L.RegioDiNC(0) L,1 4 0 Not used
RC_Setp_L.RegioDi1NC L,1 5 0 Normally open (NO) or normally closed
(NC) on digital input. 0=NO, 1=NC.
Not used in this model L,1 6 .
RC_Setp_L.RegioUDi1NC L,1 7 0 Normally open (NO) or normally closed
(NC) on universal digital input. 0=NO,
1=NC.
Not used in this model L,1 8 -
RC_Setp_L. RegioDO4NC L,1 9 1 DO4 NO/NC
RC_Setp_L.RegioDO5NC L,1 10 1 DO5 NO/NC
RC_Setp_L.RegioDilAct L,1 11 0 DI1-activation (presence/window) 
Economy/Off
RC_Setp_L.RegioMPAct L,1 12 0 Activation of Mould protection.
RC_Setp_L.RegioTermoModel L,1 13 0 EEPROM storage of Thermo model
variable (3-point actuator)
RC_Setp_L.RegioMinFanSpeed L,1 14 1 The fan is run at its minimum speed
setting if the automatic fan control
calculates that the fan can be switched
off.
Not used in this model - 15 -
RC_Setp_L.RegioComFactoryDefaults L,1 16 0 Set communication parameters to
factory settings (does not apply to
addresses):
1 = Factory settings (resets to 0)
RC_Setp_L.RegioBlockConfig L,1 21 0 Blocks the option to enter the parameter
list using the buttons on RCF.
RC_Setp_L.RegioPreventManualFanSp
eed
L,1 22 0 Prevents the fan speed from being
changed manually if the fan is not set to
auto (parameter 25).

Regin RCF Series Specifications

General

Brand	Regin
Model	RCF Series
Category	Controller
Language	English