RCF manual Chapter 10 Button management 29
Chapter 10 Button management
On/Off button
By pressing the On/Off button, RCF will switch between Off mode and Comfort/Economy
mode.
Setpoint buttons
The INCREASE and DECREASE buttons are used to change the setpoint displacement. The
desired contents of the display can be configured via the parameter list. There are four
alternatives:
1. The actual value is shown, or, when the setpoint displacement has been changed via
the INCREASE and DECREASE buttons, the setpoint value is shown in the display
together with the setpoint (thermometer) symbol.
2. The actual value is shown, or, when the setpoint displacement has been changed via
the INCREASE and DECREASE buttons, the setpoint displacement is shown in the
display together with the setpoint (thermometer) symbol.
3. The setpoint value is shown (factory setting).
4. The setpoint displacement is shown.
The basic setpoint is changeable in parameter 64 (factory setting=22°C).
Fan button
By pressing the fan button, the fan speed is set to to Low, Medium, High and Auto.
If the fan has been configured not to be affected by the controller output, the ”AUTO” option
will not be shown when pressing the fan button.
-over
To Next Page
Loading...
Need help?
General
