REMdevice t3 User Manual

Instruction Manual
Radio control devices T3, T5 and T7.
version 1.4 Genn. 10
Self cut-out
When this function is activated (factory setting), the transmitter
switches off automatically after 3 minutes of inactivity. It is restarted
when the START button is pressed.
In self cut-out condition, the equipment still uses a small amount of
energy: to avoid this unnecessary consumption, press the red
Stop/Emergency mushroom button.
Locking and Unlocking the keypad
It is possible to block the use of the transmitter as
follows:
• supply power to the transmitter by turning and
releasing the red Stop/Emergency mushroom
button
• press the buttons 1, 2, 7 together and
simultaneously the Start button S, then release.
If you try to activate the transmitter after this
operation, the Red Led (BATTERY) and the Green
one (ON), blink alternately and the transmitter
emits an acoustic warning.
To unlock the use of the transmitter, repeat the
sequence.
Battery Life
The battery is inside the transmitter. When it is run down, this is
indicated on the transmitter by the regular blinking of the Red Led
(BATTERY).
After the first signal, the radio control device is able to work perfectly
for over 30 hours consecutively.
The working life of the transmitter with a new and fully charged
battery is about 1200 hours (continuous duty in medium power
mode).
1 2
3 4
5 6
7
S
2
page 6 of 28 REMdevice
®
- ITALY

REMdevice t3 Specifications

Operating Environment

operative frequency range 1	869.700 – 870.000 MHz
operative frequency range 2	433.050 – 434.790 MHz
operating and storage temperature	-20°C / +70°C

Power

power supply option 1	12-24Vdc 1, 0A
power supply option 2	24-48Vac/dc 50-60 Hz 0.4A
power supply option 3	48-115Vac/dc 50-60 Hz 0.4A
power supply option 4	115-230Vac/dc 50-60 Hz 0.2A

Receiver Specifications

command relay contacts capacity	4A 115 Vac.
stop relay contacts capacity	4A 115 Vac.
range of control	100 mt.

Transmitter Specifications

radio frequency output power	1 to 10 mW
supply voltage	3.6 Vdc.
power consumption range	13.5 mA to 24 mA
battery	integrated lithium ions 3.6V
working autonomy	up to 1200 hours (20°C)
low battery warning	at 30 hours left

Dimensions and Weight

container dimensions	158×90×75 mm (L×H×D)
watertight case Ruby-T7 dimensions	169×266×89 mm (L×H×D)
watertight case ECOBOX dimensions	124×176×45 mm (L×H×D)
transmitter dimensions	176x85x37 mm (L×H×D)
transmitter weight	350 g