off and prevent any removal or outfl ow of
water) or the water is too warm. While
work is in progress, the fl ow of CO
must be maintained, and the
must fl ow out constantly between pipe and collar (pressure compensation).
Always ensure a suffi cient supply of refrigerant by providing a stand-by cylinder.
The only way to determine the amount
is to weigh the cylinder.
If it is necessary to change the cylinder during work, it is essential that this proce-
dure should be complete within 7 minutes to prevent the ice pack from melting.
Once work is complete, close the cylinder valve and wait until the pressure in
the high-pressure hoses has returned to normal. Remove the high-pressure
hoses. Once the ice pack has
remove the handle pieces with injector from the freeze collar and remove the
The freezing times and CO
requirements given in the table below are only to
be regarded as general guidelines and are valid for a water temperature of
approx. 20°C. The freezing times and refrigerant consumption values will there-
fore vary for higher temperatures. For freezing liquids in plastic pipes much
longer freezing times are generally required.
* Does not include work time
5. Procedure in Case of Trouble
Frost does not form on the pipe.
Freezing time still too short. Pay attention to freezing times according table.
Pumps not switched off, outfl ow of water.
cylinder is empty or cylinder valve is not open.
Choke in cylinder connector with T-distributo
Filter in front of injector nozzle blocked up. Unscrew injector nozzle, push
fi lter carefully from the back through the handle piece
, clean fi lter (blow out).
REMS Eskimo may not be thrown into the domestic waste at the end of use
but must be disposed of properly by law.
7. Manufacturer’s Warranty
The warranty period shall be 12 months from delivery of the new product to the
fi rst user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference in an unassembled condition. Replaced products and parts
shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning the product.
The legal rights of the user, in particular the right to
seller under the warranty terms, shall not be affected. This manufacturer’s
warranty only applies for new products which are purchased in the European
Union, in Norway or in Switzerland.
This warranty is subject to German law with the exclusion of the United Nations
Convention on Contracts for the International Sales of Goods (CISG).
For spare parts lists, see
→ Downloads → Parts lists.
To Next Page
Loading...
Need help?
General
