Renault Clio Cup - Page 13

2010 Release
E-13
Pivot holder
- Removal
Operations Photos
1 - Remove the wheel.
2 -
Remove the brake caliper (see 4-5 Brake
system/Front brakes/Calipers) and attach it in
the wheel arch.
3 - Remove the point E nut (1).
4 -
Extractsupport EE' from the point E ball joint; a
ball joint puller must be used to do this.
5 -
Remove the anti-roll bar mounting nut from the
pivot holder(3).
6 -
Disconnect the steering rod at the level of point
H (4).
7 -
Remove the wheel speed sensor at the level of
the pivot.
8 -
Remove the support strut mounting bolt (2)
on the pivot holder.
9 - Extract the pivot-holder support strut.
10 -
Remove the pivot-holder, pivot and EE’ support
assembly.
11 -
Remove the EE’ support (see following section)
12 -
Remove the nut from point F’.
13 -
Remove the pivot from the pivot holder using a
ball joint puller.
- Refitting
Perform the removal steps in reverse order.
Tightening torques:
 Support strut mounting bolt: 105Nm.
 Anti-rotation tie-rod nut: 100Nm.
 Point E nut : 105Nm.
 EE’ support mounting bolt on pivot holder: 105Nm.
 Point F' ball joint nut: 140Nm.
2
3
1
4