EasyManua.ls Logo

Renault K4M - Page 20

Renault K4M
993 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10A-14
ENGINE AND CYLINDER BLOCK ASSEMBLY
Crankshaft seal at gearbox end : Removal - Refitting
K4M
10A
-the front right-hand wheel driveshaft (see Front ri-
ght-hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts),
-the front left-hand wheel driveshaft (see Front left-
hand wheel driveshaft: Removal - Refitting)
(29A, Driveshafts),
-the lower engine tie-bar (see 19D, Engine moun-
ting, Lower engine tie-bar: Removal - Refitting,
page 19D-33) ,
-the crankshaft position sensor (see 17B, Petrol in-
jection, Crankshaft position sensor: Removal -
Refitting, page 17B-15) ,
-the starter (see 16A, Starting - Charging, Starter:
Removal - Refitting, page 16A-16) ,
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection).
-the engine undertray,
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-4) ,
-the air outlet pipe for the air filter unit.
a Connect the air filter box air outlet pipe to the throttle
valve.
a Torque tighten the clip on the throttle valve air in-
let pipe (6 N.m).
a Refit:
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the battery (see Battery: Removal - Refitting)
(80A, Battery),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing).
a Perform the following operations:
-fill the manual gearbox with oil (see Manual gear-
box oil: Draining - Refilling) (21A, Manual gear-
box),
- bleed the clutch control circuit (see Clutch circuit:
Bleeding) (37A, Mechanical component controls).
a Refit the engine cover.

Table of Contents

Related product manuals