Renault K4M - Exhaust Gas Recirculation Assembly: Removal - Refitting 14 A-18

14A-18
ANTIPOLLUTION
Exhaust gas recirculation assembly: Removal - Refitting
K9K
14A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery : Removal -
Refitting) (80A, Battery).
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray,
- the catalytic converter (see 19B, Exhaust, Cataly-
tic converter: Removal - Refitting, page 19B-17)
.
a Disconnect:
- the oil vapour rebreathing pipe union from the air
filter unit air outlet pipe,
- the oil vapour rebreathing pipe from the rocker co-
ver.
a Remove the oil vapour rebreathing pipe.
Essential special tooling
Ms. 583 Hose clamp pliers.
Mot. 1448 Long nose pliers for hose
clips.
Tightening torquesm
bolts of the exhaust gas
recirculation assembly
on the cylinder head
25 N.m
bolts of the exhaust gas
recirculation rigid pipe
bracket on the cylinder
head
25 N.m
bolts of the exhaust gas
recirculation rigid pipe
on the exhaust manifold
36 N.m
bolts of the exhaust gas
recirculation rigid pipe
on the exhaust gas
recirculation assembly
12 N.m
bolts of the exhaust gas
recirculation assembly
25 N.m
bolts of the exhaust gas
recirculation assembly
mounting
25 N.m
air filter unit air outlet
pipe clip on the turbo-
charger
5.5 N.m
clip of the air filter unit
air outlet pipe on the air
filter unit
5.5 N.m
IMPORTANT
Wear protective gloves during the operation.
K9K, and 832