19A-95
COOLING
Water pump inlet pipe: Removal - Refitting
F9Q
19A
-the front panel,
-the bonnet catch (see Bonnet latch: Removal -
Refitting) (52A, Non-side opening element mecha-
nisms),
-the bolts for the engine wiring harness channel,
-the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) ,
-the front bumper supports (see Front bumper
support: Removal - Refitting) (42A, Front upper
structure),
-the headlights (see Front headlight: Removal -
Refitting) (80B, Headlights),
-the frontal impact cross member (see Front im-
pact cross member: Removal - Refitting) (41A,
Front lower structure),
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the engine undertray,
-the engine cover.
a Connect the battery (see Battery: Removal - Refit-
ting) .
a Perform the following operations:
-fill the refrigerant circuit using a refrigerant char-
ging station (see Coolant circuit Draining - Re-
filling) (62A, Air conditioning).
-fill and bleed the coolant circuit (see 19A, Cooling,
Cooling circuit: Draining - Refilling, page 19A-
17) .
To Next Page
Loading...
