1.23
USING VOICE RECOGNITION (7/8)
Multimodality
Multimodality enables the user to
complete an address or a telephone
number, using voice control, which was
entered using the multimedia screen,
and vice versa.
Use
When you begin entering a telephone
number using the multimedia system
keypad:
– press the voice control button;
– complete the telephone number
using your voice or say “Call” after
the beep if you have already entered
the full number and wish to launch
the call.
House number - Continue
Start again
Help
Call
Delete
Back
Using a telephone with voice
recognition
It is possible to call a number or a con-
tact using the voice control included
with your multimedia system. To do this:
– press the voice control button to dis-
play the main voice control menu;
– say “Phone” after the beep;
– state the contact name you wish to
call, or dictate the telephone number
you with to contact.
Note: You are recommended to dictate
the numerals either one by one or two
by two.
– The system displays the stated
number, say “Call” to call the number
or “Delete”/“Start again” to dictate a
different number.
Using the voice control function, it is
also possible to:
– view the call log;
– read an “SMS”;
– call your voicemail.
To do this:
– press the voice control button to dis-
play the main voice control menu;
– say “Phone” after the beep;
– state the name of the function dis-
played on the screen that you wish
to use, then follow the instructions.
To Next Page
Loading...
