Renault RAFALE - Page 150

LIGHTING AND SIGNALS
2
148 - Getting to know your vehicle
Lights-on reminder buzzer
If the lights are on after the engine is
switched off, a warning beep sounds
whenthedriver’sdoorisopenedto
warn you that the lights are still on.
Operating faults
Depending on the vehicle, if the
"Check lighting" message appears
along with the warning light
and/or the warning flashes on
the instrument panel, this indicates a
lighting fault.
Consult an approved dealer.
"Welcome and Goodbye" function
(depending on the vehicle)
Oncethefunctionisactivated,theday-
time running lights and the rear side
lights will light up automatically upon
detectionofthecardorwhenthevehi-
cle is unlocked.
They switch off automatically:
– approximately 15 seconds after they
are switched on;
– when starting the engine, based on
the position of the lighting stalk;
or
– upon locking the vehicle.
Activating/deactivating the function
Foractivationordeactivationoftheex-
ternal welcome, refer to the multimedia
instructions.
"See-me-home lighting"
This function enables you to briefly
switch on the side lights and dipped
beam headlights (e.g. to provide light
when opening a gate).
With the engine off, after opening
the driver's door, with the ring 3 in
"AUTO" position, pull the handle 1 to-
wards you: the side lights and dipped
beamheadlightswillswitchonforap-
proximately 30 seconds along with the
and warning lights on the
instrument panel.
To increase this duration, you may pull
thestalkuptofourtimes(totaltimere-
stricted to approximately two minutes).
The"Lightingonduring___"mes-
sage appears with the lighting time on
theinstrumentpaneltoconfirmtheac-
tion. You can then lock your vehicle.
Deactivating the "See-me-home
lighting" function
To switch off the lighting before it is
done automatically, rotate the ring 3 to
anypositionthenreturnittothe"AU-
TO" position.
Note: if the "Welcome and Goodbye"
function is activated, once the engine
isswitchedoff,theprocedurefordeac-
tivating the "See-me-home lighting"
function must be carried out before
pulling the stalk (otherwise the lights
remainlitbytheWelcomeandGood-
bye function).