LIGHTING AND SIGNALS
2
Getting to know your vehicle - 149
Rear fog light
To activate this function, rotate
the ring
3
until the "AUTO" symbol is
opposite the mark
2
, then press the
rotary switch to align the mark
4
with
the symbol
7
.
Warning light comesonthein-
strument panel.
Operation of the fog lights depends on
the exterior lighting selected, and an
indicatorlightwilllightupontheinstru-
ment panel.
To avoid inconveniencing other road
users, remember to switch off this light
when it is no longer needed.
Switching off the lights
To deactivate the function, rotate the
rotary switch again so that the mark
4
is opposite the symbol
7
.
The warning light disappears
from the instrument panel.
The rear fog lights switch off when the
exterior lights are switched off.
When driving in fog or
snow, or when transporting
objects which are higher
than the roof, the headlights do
not come on automatically.
The fog lights are controlled by
the driver: the warning lights on
the instrument panel inform you
whether they are on (warning light
on) or off (warning light off).
Headlight beam adjustment
Depending on the vehicle, the switch
A
can be used to adjust the height of
the headlight beams according to the
load.
With the dipped beam headlights on,
press or raise switch
A
as many times
asrequiredtoselecttherequiredposi-
tion on the instrument panel.
Note:ifthelightsareon,ateachen-
gine start-up the selected position is
displayed on the instrument panel for
approximately 15 seconds.