- 10 -
5.2.2 Extraction force
The extraction force can be adjusted in three levels; the current ex-
traction force is shown in the display (37).
6HWWKHH[WUDFWLRQIRUFH
Button (43), increases extraction force
TButton (41), reduces extraction force
5HDGMXVWPHQWRIWKHH[WUDFWLRQIRUFH
The set extraction force applies for both suction hoses. When
another suction hose is opened or closed, the power in the
suction turbine is automatically readjusted so that the selected
extraction force may be achieved in each opened suction hose.
7RGHDFWLYDWHWKHH[WUDFWLRQIRUFHUHDGMXVWPHQW
,QWKHVWDQGE\PRGH
Press
/ buttons (43/41) together for 3 seconds.
The indicator above the button
(41) shows “OFF”.
The deactivated extraction force readjustment is shown by the “OFF” indicator above the button
(41)
permanently.
7RDFWLYDWHWKHH[WUDFWLRQIRUFHUHDGMXVWPHQW
,QWKHVWDQGE\PRGH
Press
/ buttons (43/41) together for 3 seconds.
Ƈ The indicator above the button (41) goes out.
When the extraction force readjustment is deactivated, the extraction power on one suction
hose will reduce considerably if a second suction hose is then also activated.
On extraction force level “3” with both hoses open, only a reduced extraction power is available
as the suction turbine cannot be increased any further.
The fuller the dust bag, the lower the extraction performance.
Fig.
37
43
41
5.3 Programming
The menu function enables various extractor settings to be preset and saved.
In order to set different parameter, press the menu key (30) repeatedly.
7RFRQ¿UPDQGVDYHWKHDGMXVWHGVHWWLQJVSUHVVWKHHQWHUEXWWRQ
$QDXGLEOHVLJQDOFRQ¿UPVWKDWWKHVHWWLQJVKDYHEHHQVXFFHVVIXOO\VDYHG
If you do not wish to save the adjustments, press the menu key again (30) and the programming will be
aborted.
If the word “default” is shown in the display (42) press the buttons
and (41, 43) together to revert
to the standard factory settings (see table in chapter 6.5).
MENU
A
B
OFF
ON
resetdefault
Fig. 9
30
40
41
42 43
EN
To Next Page
Loading...
