ii Preliminary information
EC DECLARATION OF CONFORMITY
Renishaw plc declares that the product:
Name Description
NC4 Non-contact tool setting system
has been manufactured in conformity with the following standards:
BS EN 61326: 1998/ Electrical equipment for measurement,
A1:1998/A2:2001 control and laboratory use - EMC
requirements. Immunity to annex A -
industrial locations. Emissions to class A
(non-domestic) limits.
BS EN 60825-1:1993/ Safety of laser products.
A1:1997/A2:2001 Part 1: Equipment classification,
requirements and user’s guide.
and that it complies with the requirements of the following
directives (as amended):
89/336/EEC Electromagnetic compatibility
73/23/EEC Low voltage
FCC
Information to user (FCC Section 15.19)
This device complies with Part 15 of the FCC rules. Operation
is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
Information to user (FCC Section 15.105)
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with this installation guide,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference, in which case you will be required
to correct the interference at your own expense.
Information to user (FCC Section 15.21)
The user is cautioned that any changes or modifications not
expressly approved by Renishaw plc or authorised representative
could void the user’s authority to operate the equipment.