EasyManuals Logo

Renishaw NC4 Installation And Maintenance Guide

Renishaw NC4
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
vi
Servicing
It is necessary to remove the access panel of the
transmitter unit to perform some servicing
procedures. A pin spanner is supplied for this
service procedure.
If electrical power is applied to the unit when this
panel is removed, personnel can be exposed to
laser radiation within the levels for Class 3R.
Before carrying out servicing procedures on the
NC4 system, switch off electrical power.
Training
Installation, user and service personnel should
receive training in the operation and use of laser
products in accordance with the international
standard IEC 60825-1:1993 + A1:1997 + A2:
2001 Section 3, Subsection 10.10.
Related publications
NCi-4 interface installation and user’s guide
,
Renishaw part no. H-2000-5236.
Non-contact tool setting system
programming guide
. The appropriate guide
is supplied with the NC software.
Servicing, training and related publications

Other manuals for Renishaw NC4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Renishaw NC4 and is the answer not in the manual?

Renishaw NC4 Specifications

General IconGeneral
BrandRenishaw
ModelNC4
CategoryTools
LanguageEnglish

Related product manuals