Reolink Argus


Chapter 8
Alarm Settings

The built-in PIR motion sensor will detect changes in temperature/radiation.
When the PIR motion sensor detects motion, it will trigger an alarm and
prompt the camera to take the following action: sound siren/alarm, send
Push Notification to your mobile devices, send E-mail alert and Record
movement to your SD card.


8.1 Setup PIR Motion Schedule
By default, the PIR motion sensor is enabled. If you want to schedule it to arm
or disarm, follow the steps below:

Steps:
1. Go to “Device Settings” > “Alarm” > “PIR Settings”. Tap on “Schedule”.



2. Tap on the Square (hour) to disable PIR detection (Grey) or tap again
to enable PIR detection (Blue).  Tap   to return to the previous page
and then tap   on the top right to save the settings.

31