10.4.7 Maintenance
Periodically clean KONDUiT base with damp cloth and/or mild detergent. Do not immerse or use
excessive fluid. Inspect connectors to make sure they are not damaged and they are securely
fastened.
KF Comm Software
KF Comm License
Copyright © 2018 Repligen Corporation, Waltham, MA, USA. All rights reserved.
Redistribution and use in source and binary forms, with or without modification, are permitted
provided that the following conditions are met:
• Redistribution of source code must retain the above copyright notice, this list of conditions
and the following disclaimer.
• Redistribution in binary form must reproduce the above copyright notice, this list of
conditions and the following disclaimer in the documentation and/or other materials
provided with the distribution.
• Neither the name of Repligen Corporation nor the names of its contributors may be used to
endorse or promote products derived from this software without specific prior written
permission.
• This software is provided by copyright holders and contributors “as is” and any express or
implied warranties or merchantability and fitness for a particular purpose are disclaimed.
• In no event shall the copyright owner or contributors be liable for any direct, indirect,
incidental, special, exemplary, or consequential damages (including, but not limited to,
procurement of substitute goods or services; loss of use, data, or profits; or business
interruption) however caused and on any theory of liability, whether in contract, strict
liability, or tort (including negligence otherwise) arising in any way out of the use of this
software, even if advised of the possibility of such damage.
11.1 Introduction
The KrosFlo® TFF System is accompanied with the KF Comm Software Suite that can be used on
Windows® PCs. The software requires Microsoft® Windows XP (32-bit or 64-bit) or newer and
Microsoft® Excel® 2007 (32-bit or 64-bit) or newer. The software also does not run on any version of
Windows CE and RT.
Repligen recommends updating both the software and firmware of the TFF systems to ensure that
all of the latest pump features are available and accessible to the customer.
For increased ease of use, the TFF system can also be controlled using the PC Control that runs when
KR2i and KMPi templates are launched. The TFF system and auxiliary components are connected to
the computer with a USB connection that is read as a virtual serial (COM) port.
To Next Page
Loading...
Need help?
General
