ResMed S9 Series Clinical Guide

21
English
Parameter Modes Default Range Description
AutoSet APAP CPAP
Options
Climate
Control
ü ü ü
Auto Auto / Manual /
Patient
Sets the type of Climate
Control.
Sleep quality
ü ü ü
Usage On / Usage Sets Sleep Quality to Usage
or On.
SmartStart
ü ü
Off On / Off / Patient Enables or disables the
SmartStart feature (only
available in the S9 AutoSet
and S9 Elite).
EPR inhale
ü
Med Med / Fast Sets the inhalation type.
Date
ü ü ü
– – Sets the current date or time.
If you set a new date or time
that occurs in the past then an
‘Invalid date/time, data exists
for this period’ message is
displayed.
Before this change can be
made, erase the compliance
data – available under the
Configuration menu.
Time
ü ü ü
– –
Configuration
Language
ü ü ü
English English / Français
/ Español /
Português
Sets the display language.
Restore
factory
defaults
ü ü ü
– – Resets machine default
settings (except for language,
date and time).
Erase data
ü ü ü
– – Allows the clinician to erase
all data stored in the unit and
SD card (except for machine
hours). Settings, date and time
are not affected.
Temperature
units
ü ü ü
o
F
o
F /
o
C Sets temperature units.
Advanced Info menu
Sleep quality
ü ü ü
– – Displays the following
information on last night’s
data:
S9 AutoSet/S9 Elite—usage,
mask fit and AHI
S9 Escape—usage only
S9 Escape Auto—AHI and
usage
View settings
ü ü ü
– – Displays Mode, Pressure,
Ramp, EPR, Mask, Tube type,
Climate Control, Sleep quality,
and SmartStart (only available
in the S9 AutoSet and S9 Elite)
settings.
368220.indb 21 6/09/2011 9:21:50 AM

ResMed S9 Series Specifications

General

Data Storage	SD card
Device Type	CPAP Machine
Pressure Range	4 to 20 cm H2O
Sound Level	24 dB
Power Supply	100-240V AC, 50/60Hz
Therapy Modes	CPAP, VPAP ST, VPAP Auto
Altitude Adjustment	Yes
Operating Temperature	+41°F to +95°F (+5°C to +35°C)
Operating Humidity	10% to 95% non-condensing
AC Voltage	100-240V AC
Humidifier	optional
Ramp	Yes