24
SD card
The SD card allows S9 devices to capture
data. The S9 Series comes with the SD card
already inserted and ready to be used.
Compliance data is also stored on the
device, so if the card is lost, the data is not.
You can also create new treatment settings
and transfer them to the patient’s device via
the SD card.
S9 device settings are written to the SD
card so that a ResMed PC application will
present actual settings from the SD card
rather than default values.
Data management
The SD card may be used to monitor patient usage as well as treatment pressure, mask leak (only
available in the S9 AutoSet and S9 Elite), and incidence of apneas and hypopneas. To assess the patient’s
progress, data for the last session may be compared to values for the last week, the last month, the last
three months, the last six months, and the last year. The device stores usage and summary data for up to
365 sessions.
Removing the card
Before removing the card, instruct the patient to disconnect the S9 device from the power outlet.
To remove the card, instruct the patient to:
1. Push in the SD
card to release
it.
2. Remove the
card.
3. Insert the
card into the
protective
folder.
4. Send the
protective folder
back to you as
instructed.
Inserting the card
1. Remove the card from the protective folder.
2. Push the card into the S9 device until it clicks.
3. The following message is briefly displayed: Reading SD card
Notes:
• For more information on removing and inserting the card refer to the S9 SD Card Protective Folder
provided with the device.
• Ask the patient to retain the S9 SD Card Protective Folder for future use.
368220.indb 24 6/09/2011 9:22:03 AM
To Next Page
Loading...
Need help?
General
