Routine Maintenance
Cleaning
the
Filter
CAUTION!
The
gray pollen
filter
should be cleaned at least once every two weeks
under normal usage and replaced
with
a new one every six months. The
white
ultra-fine
filter
is disposable and should be replaced after 30 nights of
use or sooner if it appears dirty. DO
NOT
clean the ultra-fine
filter.
Operating the
REMstar
Plus
with
a
dirty
filter
may
keep
the
system
from
working
properly
and
damage
the
REMstar
Plus.
1.
Remove the filter cap by
gently
pressing down on the two latches on
the top of the filter cap.
2.
Clean
the filter.
a.
Remove the
filter
by gently pulling around the
edges
of the
filter.
Rinse
the
filter
in a steady stream of running water. Squeeze out the
water
and
repeat.
Air
dry on a rack for 8 to 12 hours or in a clothes
dryer
for 15 to 20 minutes.
b.
Insert the clean
filter
into the
filter
area on the back of the
REMstar
Plus.
Replace the
filter
cap.
CAUTION!
Never install a wet
filter
into
the
REMstar
Plus.
We
recommend
that
you
clean the
filter
in the morning and
alternate
using the two
filters
provided
with
the
System
to ensure enough drying
time
for the cleaned
filter.
Clean
the mask and tubing daily.
To
avoid
electrical shock, unplug the
REMstar
Plus before cleaning.
Do
not
immerse
the
REMstar
Plus in any fluids.
1.
Disconnect the flexible tubing from the
REMstar
Plus. Gently wash
the flexible tubing in a solution of
warm
water and a mild detergent.
Rinse
thoroughly.
Air
dry.
2.
Wipe the outside of the
REMstar
Plus with a cloth slightly damp-
ened with water and a mild detergent. Let the
REMstar
Plus dry
before plugging in the power cord.
3.
Inspect the
REMstar
Plus and all circuit parts for any damage after
cleaning.
Replace any damaged parts.
4. For details on cleaning your mask and accessories, refer to the
cleaning instructions packaged with the accessories.
18
O
REMstar
Plus
User
Manual
Cleaning
the
System
WARNING!
To Next Page
Loading...
