Retsch Twister - Fault messages

Fault messages
33
Pos: 11.1 /00005 Ü berschriften/ 1. Überschriften/ 1 Fehlermeld ungen @ 2\m od_1259056589 728_9.doc @ 1 7580 @ @ 1
7 Fault messages
Pos: 11.2 /00010 Bedienungsa nleitungen Ka pitelsammlungen/T wister Mill ( 2011)/0035 Zyklo n Mill Twister Fe hlermeldungen/ 3501 Zyklon Mill Twister Modul F ehlermeldu ngen @ 3\ mod_1289223018 446_9.doc @ 24000 @ @ 1
F01
Motor does not run
F02
Motor switched off because of
excessive load
Restart grinding process with less
feed quantity.
F03
Motor speed too low/high
F04
Hood open
F05
Braking time too high
F06
Motor overheated
Allow the motor to cool down and
restart.
F07
Hood monitoring faulty
Check the error message:
Press the START button with the
hood open.
The “speed” segment display
flashes uniformly.
Close the hood to correct the
fault.
F08
Overspeed caused by hardware
Display
blinkt
Grinding chamber hood is not
closed or grinding chamber cover
has not been fitted
Pos: 12.1 /00010 Bedienungsa nleitungen Kapitels ammlungen/------- Seitenu mbruch ----------- @ 0\mod_1222344373 758_0.doc @ 23 86 @ @ 1