12
8.4 Loading parameters from USB key to Controller
It is also possible to load saved parameters from a USB key to the controller on the screen. By pressing
LPARA, the screen (as shown below) will list all the saved parameters files on the USB key.
Use up / down arrow to navigate and press SELCT to load the desired parameter file.
Press YES, the controller will display ‘LOADING’, when complete touch ‘QUIT’ and then ‘QUIT’ again. Touch
the ‘SETUP’ button, then the ‘EXIT’ button and power the display off. This procedure confirms all the
parameters will be refreshed to the controller’s memory.
8.5 Save Controller Logging Data to USB Key
When the truck is stopped, Press TOTAL first, then press DATA, insert the log key and press LOG, The screen
text will show “SAVING…” which will disappear after it saves the spreading log information to the USB key. (This
will also clear the logged data from the controller). Touch ‘QUIT’ and then ‘QUIT’ again. Insert the USB key into
a laptop and open the CS-530 logging Excel desktop software. The logging information will have the file name
“data_REGN_TRID.txt”, and it will be date and time stamped.
* REGION_TURC01 REGION_TURC06
REGION_TURC02 REGION_TURC07
REGION_TURC03 REGION_TURC08
REGION_TURCK04 REGION_TURC09
REGION_TURCK05
1 --- 10
QUIT NPAGE SELCT
Load REGION_TURC01 ?
To Next Page
Loading...
Need help?
General
