REXROTH CS 550/150 - Default Chapter; Table of Contents

2/29
Bosch Rexroth Canada ıJune.2016 ı Revision 2.0
Table of Contents
1
Programming Mode
3
2
Program Screen Layout
4
3
Changing Fields – Data Entry
5
4
Initial Set-up
6
5
Ground Speed Calibration
7
6
Valve Nulling – Conveyor/Spinner/Prewet/Norm
8
6.1
Auto Nulling
8
6.2
Manual Nulling
8
6.3
Spinner Width Calibration
9
7
Chute Calibration
10
8
Material Calibration
11
9
Material Catch Test
13
10
Load Parameters
14
11
Advanced Features
15
12
GPS Options and WiFi Data Transfer
16
12.1
GPS-Passive GPS Tracking
16
12.2
AVL – Active Vehicle Locating Interface
17
12.3
WiFi Data Transfer Setup
18
12.4
WiFi Desktop Program
21
13
Error Codes
22
14
Joystick Calibration
27
14.1
Joystick Solenoid Nulling
27
14.2
Joystick Emergency (Panic Button) – If Equipped
27
15
Advanced Joystick Set-up
28
15.1
Power Float
28
15.2
Function Labels
28
16
Warning
29
Bosch Rexroth Canada Corp. reserves the right to revise this information at any time and for
any reason and reserves the right to make changes at any time, without notice or obligation,
to any of the information contained in this piece of literature.
Please check for updates at: www.boschrexroth.ca/compu-spread