27/29
Bosch Rexroth Canada ıJune.2016 ı Revision 2.0
14 Joystick Calibration
14.1 Solenoid Nulling
1. Start vehicle and achieve full pump flow.
2. Tap on Joystick symbol.
3. Press “CALIBRATION” button and press a mode button on the
joystick to select a desired mode to adjust.
4. Move the joystick slightly until the hydraulic actuator moves slowly – press
“Min” while the stick is deflected.
5. Move the joystick until the actuator moves at a safe maximum speed – press
“Max”.
6. Repeat this for all axis’, directions and modes.
Press “CALIBRATION” button again to save all changes.
14.2 Emergency (Panic Button) – If Equipped
1. Select the desired mode on the joystick and pull the joystick in the direction that
the emergency button should activate.
2. Press the round “EMG” button while the stick is deflected.
Any mode or direction can be assigned to Panic Button. In operation mode when the
Panic button is pushed in conjunction with the Deadman trigger, the selected
function(s) will activate simultaneously.
This joystick calibration is only required when a multifunction CANbus Joystick
Console is included with the system.
All the mode names and special functions will be configured by the factory. Only
solenoid nulling may be required.
To Next Page