9/29
Bosch Rexroth Canada ıJune.2016 ı Revision 2.0
4. Do the same for “Max” except adjust the motor to a safe maximum speed or
until the RRM readout stops to increase.
5. Forward Gain and Blast settings can also be adjusted
6. Repeat this procedure for all the vehicle motors (i.e. Conveyor/Auger, Spinner,
Prewet, Anti-icing, etc.).
6.3 Spinner Width Calibration
1. Measure and Enter the chute ‘width’ in mm or inch
2. Press “WIDTH CAL” button to start
To Next Page
Loading...
