RF IDeas WAVE ID - Logical Unit ID; Beeper; Volume

2020 rf IDEAS Inc rfIDEAS Configuration Utility User Manual P a g e  23
Off LED is OFF
Red LED is set to always be red
Green LED is set to always be green
Amber LED is set to always be amber
Logical Unit ID
A user defined 16bit number used to identify one reader from another
Image 25: Logical Unit ID
Beeper
If equipped the reader can be configured to produce a beep when a credential is detected
by the reader
Enable Beep on Card Read Enable this to set the reader to beep when a card is read
Default is set to ON
Beep Now Simulates BEEPNOW SDK Command to BEEP the reader according to Long
Beep and Number of Beeps It is reader configuration independent
Long Beeps  By default the beep is set to a short beep 2 long beeps or 5 short beeps are
allowed
Number of beeps The minimum is 1 beep and the maximum are 5 beeps Default is set to 1
beep
Volume
Applicable only on readers equipped with Volume Control