RF IDeas WAVE ID - Reader Basics; Configuration Differences; Reader Setup Procedure

2020 rf IDEAS Inc rfIDEAS Configuration Utility User Manual P a g e  5
Chapter 
Reader Basics
11 Difference between Single Configuration and
Multi Configuration Reader
The WAVE ID Plus is a dual frequency programmable reader that combines 125 kHz and 1356
MHz technologies into the same reader Its the only reader in the industry that reads multiple
cards of your choice among many different card types delivering flexibility to any customer
struggling with different card technologies In contrast to the WAVE ID Plus reader our
standard WAVE ID Solo proximity and contactless readers function on a single frequency and
single card type which is either 125 kHz proximity or 1356 MHz contactless
12 Reader Setup
To setup the reader:
1 Connect the reader to the workstation using RS232 USB or Ethernet Must be in the
same Subnet as the workstation
2 The workstation should detect new hardware for USB connections Verify the
workstation recognizes this connection using Device Manager