RF IDeas WAVE ID - ASCII Extended Procedure

2020 rf IDEAS Inc Configuration Utility User Manual P a g e  79
In a onefactor system the user simply scans the ID card The reader may be configured to
add TAB keystrokes ahead of the data as well as a TAB or ENTER keystroke after the card
data
TwoFactor
The twofactor approach is especially useful when insisting on password construction rules
or periodic changing of passwords
In a twofactor system the user may enter the PIN either before or after the card data If the
user adds the PIN before the card data the reader may be configured to append the ENTER
keystroke
Pre and Post Characters
There are some additional measures that can be taken to make it more difficult for
unauthorized users to reproduce passwords
Adding additional keystroke characters to the card information that is difficult to re
produce while configuring the data These additional characters are labelled as Sp1 Sp2 and
Sp3 on the Delimiters Tab menu selections
ASCII Extended Procedure
STOP Before proceeding please validate that the reader has been properly preconfigured
with the Smartcard Manager Utility Contact techsupportrfideascom for more information
Referring to the figure below use the following procedure to configure the Reader to output
ASCII keystroking:
In this example 30313233343536373839 will output as 0123456789
1 Connect to the Secure Reader and insure one of the configurations has a Secure Card
types configured such as MIFARE EV1EV2 Secure File Data
2 Click on the Format tab and enable Extended mode
3 In the text box on top click Clear to remove CSN if preferred
4 Click on ASCII as Display mode
5 Click on Get ID and present the Secure Card so the full range of data shows up in the Bits
field