Beijing RuiZhitianhong technology Co.Ltd.
ADD.：A308 jiahua building, 9 Shangdi 3rd Street, Haidian District, Beijing. P.C.：100085.
Dell：+86-10-62970368/82923063 Fax：+86-10-82920078 URL：www.richnc.com.cn 32
8. C.A.D. Thickness：Unit
：
mm
This thickness should input by actual，if it is bigger than the actual theckness ,Z
axis may cut too much;if smaller, Z axis can’t touch workpiece. This parameter can
only take effect when user use auto toolsetting function.
Setting：Enter “C.A.D.Thickness”，screen shows:
Press “ ” and input the new number，press “ ” to save.
9. Max Spd Limit
（
Max Speed Limit
）
：Unit
：
mm/minute
Set machine top speed, it only take effect during processing.
Setting：Enter “Max Spd Limit”，screen shows:
Press“ ”、“ ” to move cursor to where users want to modify. Press
“ ” and input the new number ， press “ ” to save.After modifying all
options，press“ ”to confirm.
10.DistTime Limit：Unit
：
second
Users select diatance mode,and if the machine does not move in a certain period
of time(system default is 30 seconds),the system will go back to continuous mode to
To Next Page
