EasyManua.ls Logo

Richmar HydraThermDT - Symbols Glossary; Precautionary Instructions

Richmar HydraThermDT
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTIONS
The HydraTherm DT Heating Unit is
intended for clinical/professional
use ONLY.
Read, understand and practice
the precautionary and operating
instructions. Know the limitations
associated with the HydraTherm DT
Heating Unit. Observe the cautionary
and operational decals installed on the
Product.
On the initial startup of the Heating Unit
or when new packs are added check the
water level every 2 hours for a period of
8 hours. This will prevent running the
heater with low water levels as some
new heat packs absorb water.
NOTE: Richmar DOES NOT recommend
using other heat pack products, as we
have not tested the safety of those heat
packs and their use could result in injury to
patients. Richmar recommends only using
HydraHeat Packs, which do not absorb
water, used at safer temperatures than
other like heat packs, can be sanitized
between uses, and helps to reduce
maintenance tasks.
temperature levels and patients skin
should be monitored to ensure skin is
not becoming too hot. DO NOT leave
patient unattended.
Temperature readings from external
displayed temperature based on the
location of temperature reading, and
type of thermometer used. Dependent
on these factors, the temperature
reading may vary by +/- 1-2° F
ALWAYS
water temperature to stabilize prior to
temperature readings.
ALWAYS keep the water level at or
over the top of the heat packs (see
The following labels are located on
the electrical enclosure in the rear of
the unit.
HAZARDOUS
VOLTAGE
This unit is to be serviced
by trained personnel only.
WARNING
Hazardous Voltage
High Voltage is present in the electrical
enclosure located in the rear of the unit.
Service should only be accomplished by
trained personnel.
Explosion Hazard
Due to the high temperatures in which
the unit operates, DO NOT use this
unit in the presence of flammable
anesthetics.
Water Temperature
Check water temperature periodically
to ensure temperature does not exceed
150°F (65°C). For personal safety and
patient safety, please observe the
cautions as outlined in the label below.
Hot Surface
Hot surface. DO NOT touch.
3
PRECAUTIONARY INSTRUCTIONS
SYMBOLS GLOSSARY

Related product manuals