6
RACK ASSEMBLY AND RECOMMENDED PACK SET UP
The HydraTherm DT unit comes standard
with finned rack system. The finned rack
system functions as a method to not
only keep the packs separate for even
heat distribution but also as a raising
mechanism to lift the packs out for
easier removal.
Assembly Instructions
1. Align the A side of the rack to the A
side of the handle and the B side of the
rack to the B side of the rank handle.
2. Place the rack base at the edge of a
table so that the rack handle may be
positioned o the edge of the table
at a level lower than the plane of the
rack base.
3. Ensure that the keyed
feature on each side of the
handle aligns correctly with
the key-hole feature on each
end face of the rack.
4. Insert the keyed features of the handle
into the key-hole features in the rack
end faces.
5. Rotate the handle to the
vertical position and lift
the rack to the middle of
the table.
6. The handle should now be securely
fitted to the rack and should not
become dislodged unless it is fully
rotated back to the same angle at
which it was attached to the rack.
CONTENTS & REORDER INFORMATION
6
Item # Description QTY
HT-R6-DT HydraTherm DT Heating Unit 1
HT-DT-WP HydraTherm DT with 6 Standard
Heat Packs
1
DT-RACK HydraTherm Finned Rack System 1
HT-R6-X HydraTherm DT Power Cord 1
DT-HOSE HydraTherm DT Drain Hose 1
DT-FILTER HydraTherm DT Drain Filter 1
To Next Page
Loading...
