Ricoh A156 - Page 132

- A157/A159/A160 copiers -
When the paper tray is closed, the projection [A] on the tray pushes the
release lever [B], and the other projection [C] pushes the release slider [D].
Then the release slider comes off the bottom plate lift arm [E].
Once the release slider comes off, the spring [F] raises the bottom plate lift
arm and the bottom plate is lifted up. Then the top sheet of paper pushes up
the corner separators. This keeps the stack of paper at the correct height.
When the tray is pulled out, the bottom part [G] of the tray pushes the bottom
plate lift arm into the release slider.
[A]
[E]
[B]
[D]
[F]
[E]
[B]
[D]
[C]
[G]
A156/A160/A162 2-84 STM