12.4 DUPLEX ENTRANCE TO DUPLEX TRAY
The duplex feed motor [A] starts turning 500 ms after the leading edge of the
paper activates the fusing exit sensor. This motor drives the duplex feed
rollers [B] and the duplex entrance rollers [C]. The copy paper from the turn
guide section is directed to the duplex tray through these rollers.
The tip of the flip mylar [D] moves to the left (front view) when the duplex
feed rollers rotate to feed the copy into the duplex tray. The mylar presses
the copy against the duplex feed rollers, ensuring that the trailing edge of the
copy clears the guide plate.
The duplex turn sensor [E] detects the trailing edge of the paper as it enters
the tray.
Rev. 7/95
[B]
[A]
[D]
[C]
[E]
A156/A160/A162 2-100 STM
To Next Page
Loading...
