11.9.3 By-pass Feed Paper Width Detection
The by-pass feed paper width sensor board [A] monitors the paper width.
The rear side fence is connected to the terminal plate [B]. When the side
fences are positioned to match the paper width, the terminal plate slides
along the wiring patterns on the detection board. The patterns for each paper
width on the paper width detection board are unique. Therefore, the machine
determines which paper width has been placed in the by-pass feed table by
the signal output from the board.
For users with LT version models who wish to use A4 version paper sizes, or
the other way round, the paper size from the by-pass feed tray can be fixed
with SP5-019. The reading from the sensor will be ignored if this SP mode is
used to select an exotic paper size. However, if the user attempts to use a
size of paper that is different from that agreed with the technician for this
setting, a paper jam will occur.
[A]
[B]
[LT version]
[A4 version]
A156/A160/A162 2-92 STM
To Next Page
Loading...
