Figure 5:
The stapler staples the copies.
Figure 6:
The copies are pushed back into the bin. Then the grippers open and return
to the home position.
The bins move one step up for the next stapling operation.
When the final set of copies is stapled, the bins lower and stop when the
final bin that was used just before the entire stapling operation is positioned
at the bin exit.
There are two staple modes.
1) Automatic stapling:
In ADF/ARDF mode, when the user selects staple mode before pressing
the Start key, the copies will be delivered to each bin and stapled
automatically.
2) Manual stapling:
In sort mode, after copies are sorted in the bins, the copies will be
stapled when the user presses the staple key after copying. In stack
mode, manual stapling is impossible.
Figure 5
Figure 6
A156/A160/A162 6-10 STM
To Next Page
