EasyManua.ls Logo

Ricoh A156 - Magnetic Clutches, Solenoids, Lamps, Heaters

Ricoh A156
269 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Symbol
Index
No.
Description Note
Magnetic Clutches
CL1 72
Toner Supply Turns the toner supply roller to supply toner
to the development unit.
CL2 71 Development Drives the development roller.
CL3 93
Transfer Belt Contact
(1/3 Turn Clutch)
Controls the touch and release movement of
both the transfer belt unit and the drum
charge roller unit.
CL4 73 Registration Drives the registration rollers.
CL5 74
By-pass Feed Starts paper feed from the by-pass feed
table or LCT.
CL6 76 Relay Drives the relay rollers.
CL7 84
Upper Paper Feed
(Non-duplex
machines only)
Starts paper feed from the upper paper tray.
CL8 85
Lower Paper Feed Starts paper feed from the lower paper tray.
Solenoids
SOL1 75
LCT machines:
LCT/By-Pass Pick-up
Solenoid
Non-LCT machines:
By-pass Pick-up
Solenoid
Picks paper up from the by-pass feed table.
When paper is fed from the LCT, this
solenoid assists SOL3.
SOL2 91
Junction Gate
(Duplex machines
only)
Moves the junction gate to direct copies to
the duplex tray or to the paper exit.
SOL3 98
LCT Pick-up
(LCT machines only)
Picks up paper from the LCT.
SOL4 80
Upper Tray Pick-up
(A153/ machines
only)
Controls the up/down movement of the
pick-up roller in the upper paper tray.
SOL5 82
Lower Tray Pick-up
(A153/A156
machines only)
Controls the up/down movement of the
pick-up roller in the lower paper tray.
SOL6 81
Upper Tray
Separation
(A153/ machines
only)
Controls the up-down movement of the
separation roller in the upper paper tray feed
station.
SOL7 83
Lower Tray
Separation
(A153/A156
machines only)
Controls the up-down movement of the
separation roller in the lower paper tray feed
station.
Lamps
L1 17
Exposure Applies high intensity light to the original for
exposure.
L2 65
Main Fusing Provides heat to the central area of the hot
roller.
L3 66 Secondary Fusing Provides heat to both ends of the hot roller.
L4 4
Pre-transfer Reduces the charge remaining on the drum
surface before transfer.
L5 5
Quenching Neutralizes any charge remaining on the
drum surface after cleaning.
Overall Machine
Information
STM 1-15 A156/A160/A162

Table of Contents

Related product manuals