SERVICE PROGRAM MODE
B135/B138 5-4 SM
5.1.2 SERVICE TABLE KEY
Notation What it means
[range / default / step]
(initial)
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with each
key press.
italics Comments added for reference.
* Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
1111
An SP number set in bold-italic denotes a “Special Service
Program” mode setting that appears only after entering the SP
mode by pressing and holding the on the 10-key pad and then
the “Copy SP” on the touch-screen.
B135 Denotes the 35 cpm model.
B138 Denotes the 45 cpm model.
DFU
Denotes “Design or Factory Use”. Do not change this value.
Japan only
The feature or item is for Japan only. Do not change this value.
LEF Long Edge Feed
SEF Short Edge Feed
(!6.2 Image Processing) Refer to “6.2 Image Processing” in “6. Details”.
Due to fundamental changes in how image processing
adjustment is done with Group 4 SP codes, more details are
provided in Section 6.
To Next Page
Loading...
