Ricoh Aficio 2035e - Software Download Recovery Procedure

SOFTWARE DOWNLOAD
B135/B138 5-112 SM
5.2.1 SOFTWARE DOWNLOAD RECOVERY PROCEDURE
Controller
1. Turn OFF the main power switch.
2. Remove the Controller PCB.
3. Turn On DIP SW2, #1 (IC Card Boot).
4. Re-install the Controller PCB.
5. Insert the Controller firmware IC Card.
6. Power On machine. Firmware recovery will start automatically. Follow
instructions on LCD panel.
7. After the firmware download is complete, power OFF the machine, remove the
IC card, remove the Controller PCB and turn OFF DIP SW2, #1. Re-install the
Controller PCB and test machine operation.
BICU
1. Turn OFF the main power switch.
2. Remove the lower rear cover.
3. Turn ON DIP SW101, #3 (Engine Program Recovery).
4. Insert the BICU firmware IC Card.
5. Power ON machine. Firmware recovery will start automatically. Follow
instructions on LCD panel.
6. After the firmware download is complete, power OFF the machine, remove the
IC card and turn OFF DIP SW101, #3. Test machine operation.
LCDC
1. Leave LCDC firmware card installed.
2. Power the main power OFF and ON. Recovery will start automatically.
⇒
Rev. 07/2004