ORIGINAL TRANSPORT AND EXIT
B541 22 SM
4.5.2 DOUBLE-SIDED ORIGINALS
Shortly after the transport motor has been
turned on, the inverter solenoid is
activated and junction gate [A] opens. The
original is then scanned and transported
towards the reverse table [B].
Shortly after the original exit sensor [C]
detects the trailing edge of the original, the
inverter solenoid turns off and the junction
gate [D] closes.
Next, the inverter motor turns on and the
inverter roller [E] starts rotating to feed the
original from the reverse table.
Then the original is fed to the transport roller
and the scanning area [F] (where the
reverse side is scanned).
After scanning the reverse side of the
original, the original is then sent to the
reverse table [G] a second time and turned
over. This ensures that the double side
original will be properly stacked in the correct
order, front side down, in the original exit tray
[H].
B351D105.WMF
B351D107.WMF
B351D106.WMF
B351D108.WMF
[E]
[A]
[B]
[F]
[G
[H]
[C]
[D]
To Next Page
Loading...
