SERVICE PROGRAM MODE
B135/B138 5-108 SM
4. Press Execute, and then follow the prompts on the display to complete the
procedure.
5. Make sure that you perform the following settings:
• Do the laser beam pitch adjustment (SP2-109).
• Do the printer and scanner registration and magnification adjustments (!
3.21 Replacement and Adjustment, “Copy Adjustments”.
• Do the touch screen calibration (! 3.21.4 Replacement and Adjustment,
“touch screen calibration”).
• Referring to the SMC data lists, re-enter any values, which had been
changed from their factory settings.
• Do SP 3-001-2 (ID Sensor Initial Setting).
6. Check the copy quality and the paper path, and do any necessary adjustments.
To Next Page
Loading...
