SERVICE RAM ADDRESSES
SM 87 B653
Fax Option
B653
note.
6802B7 to 6802F6(H) - TTI 3 (Max. 64 characters - ASCII) - See the following
6802F7 to 68030A(H) - PSTN-1 CSI (Max. 20 characters - ASCII)
68030B to 68031E(H) - PSTN-2 CSI (Max.20 characters - ASCII)
68031F to 680332(H) – PSTN-3 CSI (Max. 20 characters - ASCII)
680333(H) - Number of PSTN-1 CSI characters (Hex)
680334(H) - Number of PSTN-2 CSI characters (Hex)
680335(H) - Number of PSTN-3 CSI characters (Hex)
NOTE: If the number of characters is less than the maximum (20 for RTI, 64 for
TTI), add a stop code (FF[H]) after the last character.
680340 to 680342(H) - PSTN-1 line settings
680340
Bits 0 and 1: PSTN access method from behind a PABX.
Bit 1 0 Setting
0 0 Loop start
0 1 Ground start
1 0 Flash start
1 1 Not used
Bit 2: Telephone line type.
0: PSTN, 1: PABX
Bits 3 and 4: Dialing type.
Bit 4 3 Setting
0 0 Pulse dialing
0 1 Not used
1 0 Tone dialing
1 1 Not used
Bits 4 to 7: Not used
680341: PSTN access number for loop start
Access number Hex value to program (BCD)
0 F0
# #
9 F9
00 00
# #
99 99
680342
Bit 0: Transmission disabled
0: Tx and Rx, 1: Rx only
Bit 1: Memory Lock reception
0: Enabled, 1: Disabled
Bits 2 to 7: Not used
680348 to 68034A(H) - PSTN-2 line settings
680350 to 680352(H) - PSTN-3 line settings
680358 to 68035A(H) - ISDN line settings (Japan Only)
680360(H) - ID code (low - Hex)
680361(H) - ID code (high - Hex)
To Next Page
Loading...
