ACCESSING IFAX BIT SWITCHES
SM 9 IFAX
IFAX
3. SERVICE TABLES AND PROCEDURES
3.1 ACCESSING IFAX BIT SWITCHES
1. Ensure that the machine is in standby mode.
2. Press , enter with the 10-key pad, then hold down for more
than 3 seconds. The SP mode main menu opens.
3. Touch “Fax SPs” on the touch-panel to enter the fax service mode.
4. Use SP1102 1~16 to set the bit switches for IFAX. For details, refer to the
Service Tables on the following pages.
WARNING
Never adjust a bit switched marked “DFU” or “Japan Only," as this may
cause the machine to malfunction or to operate in a manner that is not
accepted by local regulations. Such bits are for use only in other areas,
such as Japan.
NOTE: Default settings for bit switches are not listed in this manual. Refer to the
System Parameter List print out.
To Next Page
Loading...
