Troubleshooting
109
When you use IEEE 1394
interface board.
A Check the IEEE 1394 interface board is attached to the com-
puter correctly.
B Check the IEEE 1394 interface cable is connected securely.
C Restart the computer.
If the error occurs even after executing the above, proceed to
the following steps.
D Unplug the IEEE 1394 interface cable connected to the printer.
E Execute the utility tool for IEEE 1394 interface board is stored
in the following path on the CD-ROM labeled “Printer Drivers
and Utilities”.
UTILITY\1394
❒ For details about using the utility tool for IEEE 1394, see the
README file in the same directory on the CD-ROM.
How is the signal strength
when using the wireless
LAN?
❖ Ad Hoc Mode or 802.11 Ad Hoc Mode
Either move to a location where the signal is good or remove
obstructions.
❖ Infrastructure Mode
Check the signal status from the “Maintenance” menu on the
control panel. If the signal is poor, either move to a location
where it is good or remove obstructions.
How is the signal strength
when using Bluetooth?
Try the following:
• Check that the Bluetooth interface unit is installed properly.
• Check that there are no obstructions between the computer,
printer, and other devices.
• Change the location of the computer.
• Change the location of the printer.
Possible cause Solutions
To Next Page
Loading...
