Troubleshooting
134
Removing Punch-hole Chips
When “Empty Punch Receptacle” appears on the display, the punch waste box
is full. Follow these steps to remove paper chips.
❒ The same message appears when the punch waste box is not installed cor-
rectly.
SR960 (2 Tray Finisher)
A Open the front cover of the 2 tray finisher.
The punch waste box is positioned in the location shown in the illustration.
B Pull out the punch waste box, and then remove the paper chips.
C Re-install the punch waste box.
D Close the front cover of the 2 tray finisher.
Empty Punch
Receptacle
To Next Page
Loading...
