Adjusting the Printer
85
A Press the {Menu} key.
The [Menu] screen appears on the display.
B Press the {U} or {T} key to display “Maintenance”, and then press the
{# Enter} key.
The maintenance menu appears.
C Press the {U} or {T} key to display “Color Calibrate”, and then press the
{# Enter} key.
❒ If you want to perform only calibration 2, proceed to step
O
.
D Check “Adj.Auto Dens.” is displayed, and then press the {# Enter} key.
E Check “Now” is displayed, and then press the {# Enter} key.
The check message appears.
F Press the {# Enter} key.
Automatic density adjustment begins, and the following message appears.
❒ To avoid malfunction, do not turn off the power while “Adjusting...” appears
on the display.
Menu:
Maintenance
Press #
to adjust
Adjusting...
To Next Page
Loading...
