Facsimile Features
136
4
Changing the User Parameters
This section describes how to set parameters.
Important
❒ Access to some User Parameter Settings may require options, or other settings
may need to be made beforehand.
❒ It is recommended that you print and keep a User Parameter list when you
program or change a User Parameter.
❒ Do not change any bit switches other than those shown on the previous pages.
A Press [Facsimile Features].
B Press [Administrator Tools].
C Press [TNext].
D Press [Parameter Setting].
E Select the switch number you want to change.
F Select the bit number you want to change.
When the bit number is pressed, the current value switches between 1 and 0.
Repeat from step
F
to change another bit number for the same switch.
G Press [OK].
To cancel these settings, press [Cancel]. The display returns to that of step
E
.
H Repeat step
E
through step
G
to change the switch settings.
I After all the settings are finished, press [Exit].
J Press the {User Tools/Counter} key.
To Next Page
Loading...
Need help?
General
