Fax Destination
207
7
❖ Fax header
You can select to print a fax header on fax messages the other party receives.
The default is “1st Name".
❖ Label insertion
Use label insertion to print information such as the destination name on the
sheet printed out at the destination.
Data is printed as follows:
•Destination Name
The destination name specified in [Fax Destination] is printed with “To" be-
fore it at the top of the sheet.
• Standard Message
A registered two-line sentence is printed under “Destination Name".
To use this function, set Label Insertion to [On] when programming fax desti-
nations and also press [Label Insertion] when sending fax documents.
Fax header and label insertion are also printed when sending by e-mail using
the fax function.
You can program a standard message other than those registered in the ma-
chine. See “Programming, Changing, and Deleting Standard Messages", Fac-
simile Reference
You can program the following items in an IP-Fax Destination:
❖ IP-Fax
Register the IP-Fax destination. You can register the name using up to 128
characters. You must make this setting when using IP-Fax.
This setting only works if the IP-Fax function has been selected.
❖ SUB Code
Registering a SUB Code allows you to use Confidential Transmission to send
messages to the other fax machines which support a similar function called
“SUB Code". See “SUB Code", Facsimile Reference.
❖ SEP Code
Registering a SEP Code allows you to use Polling Reception to receive faxes
from the other fax machines which support Polling Reception. See “SEP
Code", Facsimile Reference.
❖ Select Protocol
Select the protocol for the IP-Fax transmission.
This setting only works if the IP-Fax function has been selected.
Reference
p.241 “Registering Names to a Group”
p.249 “Registering a Protection Code”
To Next Page
Loading...
