Registering Addresses and Users for Facsimile/Scanner Functions
228
7
Changing the registered SMB folder
This section describes how to change the registered SMB folder.
A Press [Change] under "Path".
B Enter the New path where the folder is located, and then press [OK].
You can also use Browse Network to specify a new folder. For details, see "Lo-
cating the SMB folder using Browse Network".
Reference
p.226 “Locating the SMB folder using Browse Network”
To change the protocol
This section describes how to change the protocol.
A Press [FTP] or [NCP].
B A confirmation message appears. Press [Yes].
Changing the protocol will clear all settings made under the previous proto-
col.
C Enter each item again.
Reference
p.230 “Registering a FTP Folder”
To Next Page
Loading...
