Deleting Data on the Hard Disk
113
3
G Enter the number of times that you want to overwrite using the number
keys, and then press [q].
H Press [OK].
Auto Erase Memory is set.
Important
❒ When Auto Erase Memory is set to "On", temporary data that remained on
the hard disk when Auto Erase Memory was "Off" might not be overwrit-
ten.
Note
❒ Should the main power switch of the machine be turned off before over-
writing is completed, the temporary data will remain on the hard disk un-
til the main power switch is next turned on and overwriting is resumed.
❒ If the overwriting method is changed while overwriting is in progress, the
remainder of the temporary data will be overwritten using the method set
originally.
Canceling Auto Erase Memory
A Follow steps
A
to
D
in "Auto Erase Memory Setting".
B Press [Off].
C Press [OK].
Auto Erase Memory is disabled.
Note
❒ To set Auto Erase Memory to "On" again, repeat the procedure in "Auto Erase
Memory Setting".
To Next Page
Loading...
